Home > pallet wrapping machine > Particles machine class: the principle of ground particles machine decryption
Particles machine class: the principle of ground particles machine decryption
2012-06-27 by seoer9

  Why DIY or purchase the ground, because the particle-paste filling machinepower system circuit is the use of Ground ground loop current flows through the load (R1), flow back into the battery after the grounding ground loop (R2), the current flows through R1 and R2, two loop, potentially reducing the output of the current I = V / (R1 + R2) can be learned, so the purpose of the grounding line of the particle machine is to reduce the R value of ground loops, reduce current consumption and increase current output, while with differences in commercially available ground wire is homemade grounding line can be connected for the Tribute & Escape particles machine active component circuit design, each node point of the distribution of the active components of the particle machine, exactly, will not have the problem of insufficient length, can take full advantage of the particles the performance of the machine active components, and commercial ground wire, not active element loop for the particle machine, so even if you are on the full particle machine room, can not take full advantage of the performance of the active components of the particle machine, because the general particle machine active components of the distribution point, usually around the particle machine, different particle machine particles machine the active component distribution point is not the same, commercially available ground wire usually can not be fully connected, there will be less than the length or the problem of long.

  The ◎ wire Material:

  A: different metal conductors (wires) may decide the conductor of the internal resistance of the size of the "conductor" according to the conductivity can be divided into silver → Cu → Gold → aluminum → W → Ni → Fe, so the conductor according to the internal resistance of the size of Fe> Ni> W> Gold> Cu> Ag.

  B: Wire material selection, according to the circuit characteristics and current needs, it is recommended that multi-core wire to the silver wire, or high purity copper as a conductor. (Radio is generally recommended that a single silver heart line, high-frequency response better)

  C: The diameter of the selection, according to current law CLK, the current flows into the equal to the current outflow, so the diameter size of the positively charged diameter as a reference. And because of the relationship of the load effect, the current will be losses, so the actual negative-side current to the positive terminal of the current small. (Recommended diameter 8mm)

  Particles machine current loop block diagram

  The ◎ circuit description:

  A: ABC ... H. said particles negative loop of contact ● The green line is the installation of the negative loop.

  B: black line is the original negative loop ● red line is the original positive loop.

  C: labeled (R) direction of the current quality of the internal resistance of the conductor positive (+) for the outflow of the negative (-) for the inflow.

  A: Generator (before the installation of ground) → battery charging current circuit for the generator (+) → Battery (-) → R3 → R2 → generator

  Generator after the installation of ground charging current loop generator → battery (+) → Battery (-) → generator

  B: high tension coil (not the installation of ground) current loop for the battery (+) → the ECU → high tension coil → R2 → R3 → Battery (-)

  Installation of ground after the high tension coil current circuit for the battery (+) → the ECU → high tension coil → Battery (-)

  C: particle powder packing machine (not the installation of ground) the discharge circuit of the particles machine → cylinder block → R2 → R3 → Battery (-)

  Particles machine after the installation of ground discharge circuit of the cylinder body of the particle machine → → Battery (-)